61
Lighting and visibility
4
Exterior lighting control
stalk
Main lighting
Automatic illumination of lamps/daytime
running lamps
Sidelamps only
Dipped or main beam headlamps
Headlamp dipping
► Pull the stalk to switch between dipped and
main beam headlamps.
In “AUTO” and sidelamps modes, the driver can
switch on the main beam headlamps temporarily
(“headlamp ash”) by pulling the stalk.
Display
Illumination of the corresponding indicator
lamp on the instrument panel conrms that the
selected lighting is on.
A fault with a lamp is signalled by the
permanent illumination of this warning
lamp, accompanied by the display of a message
and an audible signal.
Rear foglamps
They only work if the dipped or main
beam headlamps are on.
► Rotate the ring forwards/backwards to turn
them on/o.
When the lighting is switched o automatically
("AUTO" position) the foglamps and the dipped
beam headlamps remain on.
Front foglamps/Rear
foglamps
They operate with the sidelamps, dipped
or main beam headlamps on.
► Rotate the ring forwards:
• once to switch on the front foglamps,
• a second time to switch on the rear
foglamps.
► Turn in the opposite direction to switch o.
If the lighting is switched o automatically
("AUTO" position) or the dipped beam
headlamps are switched o manually, the
foglamps and sidelamps remain on.
► Rotate the ring backwards to switch the
foglamps o; the sidelamps will then switch o.
Switching on the foglamps is prohibited
in clear weather or in rain, both day and
night. In these situations, the power of their
beams may dazzle other drivers. They must
only be used in fog or falling snow (rules may
vary depending on country).
Do not forget to switch o the foglamps when
they are no longer necessary.
Switching o of the lamps when the
ignition is switched o
When the ignition is switched o, all of the
lamps turn o immediately, except for dipped
beam headlamps if automatic guide-me-home
lighting is activated.
To Next Page
Loading...
