227
Practical information
Towing the vehicle
Procedure for having your vehicle towed or
for towing another vehicle using a removable
towing eye.
Towing your vehicle Towing another vehicle
Access to the tools
The towing eye is installed in the boot under
the floor.
To gain access to it:
open the boot,
remove the towing eye, located in the tool
box.
On the front bumper, unclip the cover by
pressing at the bottom to disengage the
securing lugs.
Screw the towing eye in fully.
Install the towing bar.
Switch on the hazard warning lamps on the
towed vehicle.
On the rear bumper, unclip the cover by
levering at the left with the point of the
towing eye.
Screw the towing eye in fully.
Install the towing bar.
Switch on the hazard warning lamps on the
towed vehicle.
When towing with all four wheels on the
ground, always use a towing bar.
When towing with only two wheels on
the ground, always use professional
lifting equipment.
When towing with the engine off, there
is no longer any braking or steering
assistance.
Place the gear lever in neutral
(position N with an electronic or
automatic gearbox).
Failure to follow this advice could
result in damage to certain braking
components and the absence of
braking assistance the next time
the engine is started.
To Next Page
Loading...
