EasyManua.ls Logo

Claas LEXION 540 C - Maintenance Safety Procedures

Claas LEXION 540 C
41 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
40 00 0299 524 7 - BA LEXION 560 - 510 - 12/09
3 Safety Rules
3.1 Safety rules
66259
2422
3.1.10 Air conditioner
The air conditioning system is filled with
CFC refrigerant. CFC refrigerants must not be
allowed to escape into the atmosphere.
- Therefore, please take appropriate precautions
when working on the air conditioner.
Maintenance and repair work may only be carried
out by specialised air conditioning system service
workshops. Refrigerant must always be sucked
out and disposed of for recycling.
5965
3.1.11 Maintenance
Repair, service and cleaning work and the elimi-
nation of malfunctions should only be performed
with the drive and the engine switched off
remove the ignition key and turn off the battery
isolating switch!
Escaping fluid (fuel or hydraulic oil) under high
pressure can penetrate the skin and cause seri-
ous injuries. If any fluid is injected into the skin,
consult a doctor immediately as otherwise serious
infections may result!
Be careful when opening the radiator cap. The
radiator is under pressure when the engine is hot!
Dispose of oil, fuel and filters in a way that is
harmless to the environment and in accordance
with existing anti-pollution regulations!
Do not attempt to mount a tyre unless you
have the proper equipment and experience
to perform the job safely!
Retighten the wheel nuts and wheel bolts
regularly!
Only have qualified workshops carry out repair
work on the hydraulic system.
5966
3.1.12 Basic rule
Always check the operational safety and road
safety of the combine before starting the engine!
5968
3.1.13 Accumulators
Be especially careful when working on the accu-
mulators! Accumulators are under high pressure!
With valve-controlled hydraulic accumulators – as
for example on the CLAAS Autopilot – first
slacken the short-circuit bolt before carrying out
any repair work at the hydraulic accumulator. This
is necessary to relieve the hydraulic pressure.

Other manuals for Claas LEXION 540 C

Related product manuals