31
Settings: Side Knife/Divider
Once the side knife is fitted and locked, all that is required is for two hydraulic
pipes to be connected to the quick release couplings on the side of the cutterbar.
TIP. Make sure the cutterbar VARIO table is pushed out to the mark on the
side of the cutterbar before fitting the knife.
TIP. There is no need for a link pipe to be connected when the side knife is
removed.
TIP. When fitting the side knife
make sure that the cradle is tight
to the underside of the tube.
Both the side knife and the divider
use the new fork locating and locking
device.
For the side knife simply slide into
the lock and turn the handle to lock in
place. Make sure the lever has locked
into the locking device.
The side knife is easily attached with
a simple twist lock turnbuckle.
To Next Page
Loading...
