Why is the time of day flashing on my Clack Valves WS2?
If the time of day is flashing on and off on your Clack Valves Water System, it's likely due to a power outage. Reset the time of day. If the PC Board has battery back up present the battery may be depleted.
Why is my Clack Valves Water System delivering hard water?
If you're getting hard or untreated water from your Clack Valves Water System, here's what might be happening: * The bypass valve might be open or faulty. Make sure it's fully closed, or replace it. * High water usage could have exhausted the media. Check your program settings for abnormal water usage. * The meter might not be registering. Remove it and check for rotation or any foreign material. * There might be a fluctuation in water quality. Test the water and adjust the program values accordingly. * The regenerant tank might be empty or have a low level of regenerant. Add the proper regenerant to the tank. * The control might be failing to draw in regenerant. Refer to Trouble Shooting Guide number 12. * There might be an insufficient regenerant level in the regenerant ta...
Explains the filter's capability to remove iron and manganese contaminants.
Describes the two-stage process of backwashing the filter media.
Details the required quality parameters for the incoming raw water supply.
Requirements for the electrical supply, including voltage, fuse, and plug.
Step-by-step guide for assembling the filter vessel, riser, and valve.
Detailed steps for performing the final commissioning of the filter system.
Troubleshooting steps for issues related to insufficient or no water flow.
Diagnosing and resolving problems with the quality of the filtered water.
Steps to take when the filter's backwash cycle is not initiating or completing.
General| Model | WS2 |
|---|---|
| Type | Control Valve |
| Operating Pressure | 20-125 psi |
| Application | Water Softening |
| Water Temperature | 34-110°F |
| Regeneration | Downflow or Upflow |
To Next Page
