Sirius Satellite Radio Operations
Category selection function
SIRIUS Radio allows you to select broadcast
channel category (contents).
Receiving channels selected
by
category
This starts seek tuning and broadcast channels
that meet the specified category are selected.
The "CAT" indicator is displayed during the
category selection mode.
1.
Press the [CAT] button to enter the category
selection mode.
2. Turn the [ROTARY] knob clockwise or
counterclockwise to select a category.
Or,
press a [DIRECT] button if the category
is preset.
3.
Press the
[<~]
or
[~>]
button to tune
in
a
channel.
4. Press the [CAT] button again to cancel.
Notes:
• When the category selection mode is entered,
the category
of
the last received channel is
displayed first.
• The category selection mode is canceled when
no channel with the selected category can
be
found.
• Press the
{<~l
or
{~>l
button within 7 seconds
after
a channel has been
set
to continue seeking
channels up
or
down. The category selection
mode is canceled
and
normal reception is
resumed
if
no operation is performed for 7
seconds.
Presetting a category
A category can be preset by registering specific
categories
in
[DIRECT] buttons 1 to
6.
Then the
desired category can be recalled by pressing
the corresponding [DIRECT] button.
1.
Press the [CAT] button to enter the category
mode.
2. Turn the [ROTARY] knob clockwise or
counterclockwise to select a category.
3. Press and hold one of the [DIRECT] buttons
for 2 seconds or longer to store the current
category into preset memory.
Notes:
• When the name
of
a channel stored in memory is
changed
by
a broadcasting channel, the display
may
show
a channel name. that differs from the
stored name.
• A channel stored in memory
may
be
discontinued
at
the option
of
the broadcasting
channel.
Category scanning
In
a category scan, broadcast channels
in
the
same category as the current channel are
selected about every 10 seconds.
1.
Press and hold the [CAT] button for 1 second
or longer to start a category scan.
2. Press the [CAT] button, a [DIRECT] button,
the
[<~]
or
[~>]
button to cancel a category
scan.
Note:
• Category scanning is
not
available when no
category is defined for the current channel.
CMD4 19
To Next Page
Loading...
Need help?
General
