,
,--,
"
__
,
/--
r-
(::;,;;/
I I I
II I
r-
I I r-
,
ilC
1111
_:i
~
Sub
display (Satellite
mode
only)
Clock
display
Main display
* Once selected, the preferred display becomes
the display default. When a function
adjustment such as volume is made, the
screen will momentarily switch to that
function's display, then revert back to the
preferred display several seconds after the
adjustment.
Switching
the
display
Press and hold the [DISP] button for 1 second
or
longer to select the desired display.
Each time you press and hold
the
[DISP] button,
the display switches in the following order:
Main display
Adjusting
the volume
Turning the [ROTARY] knob clockwise
increases the volume; turning it
counterclockwise
decreases
the
volume.
"The
volume level is from 0 (minimum) to 33
(maximum).
Note:
Be sure to read this chapter referring
to
the front diagrams
of
chapter
"3.
CONTROLS" on page 5 (unfold).
AWARNING
When
the
front
panel
is
open
t
no
sound
is
produced,
and
source
unit
controls
and
remote control
unit
operationsare disabled.
Always
shut
the
front
panel after
changing
the CD.
EXPOSING
THE
UNITTO
WATER
WITH
THE
FRONT
PANEL
OPEN
WILL
CAUSE
DAMAGE
OR
UNIT
MALFUNCTION!
Lower the volume level before powering the
source
unit
off. The
source
unit
stores
the
last
volume
setting. If the
source
unit
is
powered
off
with
the
volume
up,
when
the
source
unit
is
powered
back
on,
the
sudden
loud
volume
may
harm
your
hearing
and/or
damage the
source
unit.
Turning
on/off
the
power
1.
Press
the
[POWER]
button.
2.
The
illumination and display on the unit light
up. The
unit
automatically
remembers
its last
operation
mode
and will automatically switch
to display that mode.
3.
Press and hold
the
[POWER]
button
for
1
second
or
longer
to turn
off
the
power
for the
unit.
Note:
• System check
During the initial
power
up
of
this unit, it wiff go
through
a system check procedure. This
procedure verifies
any
devices connected through
GeNET.
Any
additional GeNET devices plugged
into the unit after the initial power up wiff initiate
the system checkprocedure. The system check
starts automatically within the unit.
Selecting a
mode
1.
Press the [CD/CDC], [SAT],
[AM/FM]
or
[iPod/AUX]
button to change the operation
mode.
* External equipment not connected with
CeNET is not displayed.
IBasic Operations
RIR~[d
12
CMD4A
To Next Page
Loading...
