I
Operations
Common
to Each Mode
Adjusting
the non-fader
*The factory default setting
is
"NFVOL
+6".
(Adjustment range:
-6
to +6)
1.
Press
the
[MENU]
button to switch to
the
menu mode.
2.
Press the
[1<1III
..
or
[~]
button
to
select
"NF
VOL".
3.
Turn the [ROTARY] knob to adjust
the
non-
fader
volume.
4. Press the
[MENU]
button
to
return to
the
previous mode.
Adjusting
the
display
contrast
You
can adjust
the
display contrast to match the
angle of installation of
the
unit.
*The factory default setting is
"5".
(Adjustment
level:
1
to
8)
1.
Press the
[MENU]
button to switch to the
menu mode.
2.
Press the
[1<1III
..
] or [...
~]
button to select
"CONTRAST"
.
3.
Turn the [ROTARY] knob
to
adjust the
contrast.
4.
Press the
[MENU]
button to return
to
the
previous mode.
Selecting
AUX
IN
sensitivity
Make
the
following settings to select
the
sensitivity when
sounds
from external devices
connected to this unit are difficult
to
hear
even
after adjusting the volume.
*The factory default setting
is
"MID".
1.
Press the
[MENU]
button
to
switch
to
the
menu
mode.
2.
Press the
[l-IllIl"]
or
[...
~]
button to select
"AUX
SENS".
3.
Turn
the
[ROTARY] knob to select from
"HIGH", "MID"
or
"LOW".
4. Press the
[MENU]
button
to
return to the
previous mode.
Performing a
system
check
This function verifies the devices
hooked
up
through CeNET.
1.
Press the
[MENU]
button
to
switch
to
the
menu mode.
2.
Press the
[1<1III,,]
or
[...
~]
button to select "S-
CHECK".
3.
Press and hold the [ENT] button for 1 second
or
longer
to
start the system check.
CeNET
connection configuration is
automatically checked.
When the system
check
is complete, the
display returns to the previous mode.
AUX
function
This
system has an external input
jack
so you
can listen to sounds and music from external
devices
connected
to this unit.
CM04A
17
To Next Page
Loading...
Need help?
General
