Note:
Be
sure to
read
this chapter referring to the front diagrams of
chapter
"2.
CONTROLS"
on
page
3.
: bass emphasized
: treble emphasized
: bass and treble emphasized
: no sound effect
Basic Operations
Be
sure
to
lower
the
volume
before
switching
off
the
unit
power
or
the
ignition
key. The
unit
remembers
its
last
volume
setting.
If
you
switch
the
power
off
with
the volume up, when
you
switch
the power backon, the sudden loud
volume may
hurt
your
hearing and damage the
unit.
Turning
onloff
the power
Note:
•
Be
careful about using this unit for a long time with-
out running the engine.
If
you
drain the car's bat-
tery too far, you may not
be
able
to
start the engine
and this can reduce the service life of the battery.
1. Press the [SRC] button.
2. The illumination and display on the unit light
up. The unit automatically remembers its last
operation mode and will automatically switch
to display that mode.
3. Press and hold the [SRC] button for 1 second
or longer to turn off the power for the unit.
Selecting a mode
1. Press the [SRC] button to change the opera-
tion mode.
2.
Each time you press the [SRC] button, the op-
eration mode changes
in
the following order:
Radio mode
-+
CD mode
-+
Radio mode...
Note:
•
If
the CD mode
is
selected when
no
disc
is
inserted,
the display shows "NO DISC".
Adjusting
the
volume
Turning the [ROTARY] knob clockwise increases
the volume; turning it counterclockwise decreases
the volume.
*The volume level
is
from 0 (minimum) to 33 (maxi-
mum).
10
08255
Setting
the
Z-Enhancer
This unit are provided with 3 types of sound tone ef-
fects stored
in
memory. Select the one you prefer.
*The factory default setting
is
Z-EHCR OFF.
Each time you press the [Z] button, the tone ef-
fect changes in the following order:
Z-ENHANCER 1
-+
Z-ENHANCER 2
-+
Z-EN-
HANCER 3
-+
Z-EHCR OFF
-+
Z-ENHANCER
1...
•
Z-ENHANCER
1
•
Z-ENHANCER
2
•
Z-ENHANCER
3
• Z-EHCR
OFF
Audio
mode adjustments
Press the [A-M] button to select the adjustment
mode. The mode switches as follows each time
the [A-M] button is pressed:
BASS
-+
TREB
-+
BAL
-+
FAD
-+
Previous mode
*The display returns to the previous mode 7 sec-
onds after the adjustment.
Adjusting
the bass
1. Press the [A-M] button and select "BASS".
2. Turning the [ROTARY] knob clockwise empha-
sizes the bass; turning it counterclockwise at-
tenuates the bass.
*The factory default setting
is
"0".
(Adjustment
range:
-7
to +7)
Adjusting
the treble
1. Press the [A-M] button and select "TREB".
2.
Turning the [ROTARY] knob clockwise empha-
sizes the treble; turning it counterclockwise
attenuates the treble.
*The factory default setting
is
"0".
(Adjustment
range: -7 to +7)
To Next Page
Loading...
Need help?
General
