Clarion DVC920 - Setting Acoustic Features (ADJUST MODE)

280-7804-00
DVC920 9
Selecting adjust mode settings
Adjust the settings to suit your sound system.
1. Press the [ADJUST] button to enter the AD-
JUST MODE.
2. Press the [ ] or [ ] [DISP] button to select
item to set.
Each time the [ ] or [ ] [DISP] button is
pressed, the indications change as shown
below.
Adjust the contrast
(CONTRAST)
Set speaker to on or off
(SP-SEL )
Set speaker filter frequency
(FILTER )
Adjust speaker output level
(SP-GAIN )
Set speaker delay time
(DELAY )
Set Dolby digital
(Dolby D )
Set Dolby Pro Logic II
(PL II CNT )
• This function is only available Dolby PL II’s
music mode selected in Dolby D function.
Set parametric equalizer
(P.EQ )
Adjust the RCA input sensitivity
(RCA SENS)
Press the [ADJUST] button to return to the
original mode.
3. When an is displayed at the end of a set-
ting, press the [ENT] button to enter the ad-
just mode.
• When no appears at the end of a menu
item, the display will return to the setting
contents after two seconds.
4. Press the [ ] or [ ] [VOL] button to adjust
the value.
5. Press the [ADJUST] button to return to the
original mode.
Adjusting contrast (CONTRAST)
This function is used to adjust display contrast.
• The initial value is [CNTRST.4].
1. Press the [ADJUST] button to enter the AD-
JUST MODE.
2. Press the [ ] or [ ] [DISP] button to show
the [CONTRAST] display.
3. Press the [ ] or [ ] [VOL] button to adjust
the contrast from [CNTRST.1] to [CNTRST.7].
4. Press the [ADJUST] button to return to the
original mode.
• The adjustment range is [CNTRST.1] to
[CNTRST.7].
Turning speakers on or off (SP-SEL)
The center speaker, rear (surround) speakers
and sub woofer have to be set to on or off to
achieve maximum sound quality.
• The initial setting is [ON].
1. Press the [ADJUST] button to enter the AD-
JUST MODE.
2. Press the [ ] or [ ] [DISP] button to change
to the [SP-SEL ] display.
3. Press the [ENT] button to display the adjust-
ment item.
Press the [ ] or [ ] [DISP] button to select
[CTR-SP], [SRD-SP] or [SUB-W].
• CTR-SP: center speaker
• SRD-SP: rear (surround) speaker
• SUB-W: subwoofer
4. Press the [ ] or [ ] [VOL] button to select
[ON] or [OFF].
• ON: Speaker installed
• OFF: Speaker not installed
• When a sub woofer is used, set [ON+], [ON-]
or [OFF]. The normal setting is [ON+], but
use the [ON-] setting when this provides a
better effect for low frequency range.
Setting Acoustic Features (ADJUST MODE)
280-7804-00_09-18(En) 2/22/02, 2:06 PM9