Clarion DXZ785USB User Manual

Basic Operations
English
18 DXZ785USB
● Adjusting the bass
2-1. Select “BASS”.
3-1. Press the [ ] button.
3-2. Push the [P.CH] button upward or
downward to adjust the gain from –6 to +6
(The factory default setting is “0”).
3-3. Press the [ ] button to return to the
previous mode.
● Adjusting the treble
2-1. Select “TREBLE”.
3-1. Press the [ ] button.
3-2. Push the [P.CH] button upward or
downward to adjust the gain from –6 to +6
(The factory default setting is “0”).
3-3. Press the [ ] button to return to the
previous mode.
● Adjusting the sound restorer
The sound restorer enriches the playback of all
types of music files that have undergone any
level of data compression.
2-1. Select “S RESTORER”.
3-1. Push the [P.CH] button upward or
downward to adjust.
Each time you push the [P.CH] button, the
sound restorer changes in the following
order:
“OFF” ↔ “1” ↔ “2” ↔ “3”
∗ The factory default setting is “OFF”.
Set this adjustment in accordance with the
music source used.
OFF: For music sources compressed at
high bit rate
1: For music sources compressed for high
quality at low bit rate
2: For music sources compressed for
standard quality at low bit rate
3: For music sources compressed for low
quality at low bit rate
● Adjusting the balance
2-1. Select “BALANCE”.
3-1. Push the [P.CH] button upward to
emphasize the sound from the right
speaker, push the button downward to
emphasize the sound from the left speaker.
∗ The factory default setting is “0”.
(Adjustment range: L12 to R12)
● Adjusting the fader
“FADER” can be adjusted only when the
speaker system is set to “2WAY” or “NORMAL”.
2-1. Select “FADER”.
3-1. Push the [P.CH] button upward to
emphasize the sound from the front
speaker, push the button downward to
emphasize the sound from the rear
speaker.
∗ The factory default setting is “0”.
(Adjustment range: R12 to F12)
● Setting high pass filter
“HPF” can be adjusted only when the speaker
system is set to “NORMAL”.
2-1. Select “HPF”.
3-1. Push the [P.CH] button upward or
downward to select the setting. Each time
you push the [P.CH] button, the setting
changes in the following order:
“THRGH” ↔ “50Hz” ↔ “80Hz” ↔ “125Hz”
∗ The factory default setting is “THRGH”
(through).
● Setting low pass filter
“S-W LPF” can be adjusted only when the
speaker system is set to “NORMAL” .
∗ If subwoofer function is set to “ST” or “MONO”,
“S-W LPF” can be selected.
2-1. Select “S-W LPF”.
3-1. Push the [P.CH] button upward or
downward to select the setting.
Each time you push the [P.CH] button, the
setting changes in the following order:
“THRGH” ↔ “50Hz” ↔ “80Hz” ↔ “125Hz”
∗ The factory default setting is “THRGH”
(through).

Clarion DXZ785USB Specifications

General

Brand	Clarion
Model	DXZ785USB
Category	Car Receiver
Language	English