PN-3001P
PP-3001M
- 1 -
Service Manual
Published by Service Dept.
Printed in Japan
Clarion Co., Ltd.
7-2, Shintoshin, Chuo-ku, Saitama-shi, Saitama 330-0081 Japan
Service Dept.: 7-2, Shintoshin, Chuo-ku, Saitama-shi, Saitama 330-0081 Japan
Tel: +81-48-601-3705 FAX: +81-48-601-3804
298-6503-00
Oct.2007
Model
NISSAN Automobile Genuine
1CD LW/MW/FM/RDS Bluetooth
Combination
PN-3001P-A
(Genuine No.28185 9U10A)(ID No. CY02E)
(ES color : Black)
PP-3001M-A
(Genuine No.28185 BG10B)(ID No. CY01E)
(ES color : Brown)
PP-3001M-B
(Genuine No.28185 BG10A)(ID No. CY00E)
(ES color : Black)
SPECIFICATIONS
Radio section
Tuning system: PLL Frequeency synthesizer sys-
tem
Receive range: LW 153kHz to 279kHz
MW 531kHz to 1,602kHz
FM 87.5MHz to 108.0MHz
Intermediate frequency:
LW/MW/FM
10.7MHz
Quieting sensitivity: LW Less than 45dBu
(at 20dB S/N)
MW Less than 32dBu
(at 20dB S/N)
FM Less than 10dBu
(at 30dB S/N)
Separation: FM 22+5/-7dB(1kHz)
S/N ratio: LW More than 40dB
MW More than 40dB
FM More than 50dB
Auto tuning stop sensitivity:
LW/MW
40+6/-6dBu
FM 22+6/-6dBu
CD section
Disc: 12cm disc
Separation: More than 50dB
(IkHz, 20kHz L.P.F)
S/N ratio: More than 74dB(JIS-A)
Distortion: Less than 0.2%(20kHz L.P.F.)
General
Load impedance: 4ohm/CH
Power output: 40W x4
Power supply voltage: DC13.2V(10.8 to 15.6V)
Negative ground
Back-up consumption: Less than 0.5mA
Dimensions(mm): 178(W) x 100(H) x 163(D)
Weight: 1.6kg
NOTES
* As for this model, the tuner of the DSP type is used.
When you exchange it due to the tuner pack(BL101;880-
2091M) trouble, it is necessary to adjust for S-meter etc.
Special JIG is necessary for an accurate adjustment. The
procedure document for the exclusive use jig is appended
to it.
* This DSP IC SAF7730HV/N317(IC301) of Main PWB is
exposed die soldering pad type. It cannot remove in an
ordinary soldering iron.
Please use special removal JIG at the time of IC ex-
change
* The word mark and logos are owned by the
Bluetooth SIG, Inc. and any use of suchmarks by
CLARION CO.,LTD. is under license.
* We cannot supply PWB with component parts in prin-
ciple. When a circuit on PWB has failure, please repair it
by component parts base. Parts which are not mentioned
in service manual are not supplied.
* Specifications and design are subject to change without
notice for further improvement.
Model
Model
To Next Page
Need help?
General
