13
.
silence alarm without disarm
This feature makes it possible to silence and reset the system while it is
triggering, without disarming the system. If the system is triggered and
the siren has been sounding for longer than six seconds, pressing
on the remote will stop the trigger and return the unit to the armed
state. The system will not disarm, but rather reset. This prevents you
from disabling the system should you wish to disarm it without visually
checking the vehicle. Pressing after resetting the system will disarm
the system; pressing this button during the first six seconds of the trig-
gered sequence will disarm the security system immediately. The six sec-
ond timer is provided for your convenience, in case the system is acci-
dentally triggered.
disarming without a remote
If your remote is lost or damaged, you can manually disarm your vehi-
cle security system. To disarm the system without a remote, you must
have the vehicle's ignition key and know where the override switch is
located. Be sure to check with your installer at the time of installation
for both the location and the preset response (1-5 presses) of the over-
ride switch.
To Next Page
Loading...
Need help?
General
