Clarion VX404AU - Preset Scan

42
VX404AU
English
English
Owner’s Manual
English
Owner’s Manual
1. Touch the option button [ ] to open option menu
display.
2. In Option Menu, touch the [Start] button.
3. Touch the [OK] button to start updating the service
list,touchthe[Cancel] button to cancel this operation
then back to previous menu.
4. When scanning the services, this image will display.
Notes:
After service scan, currently available services will be
updated in the Ensemble List and PTY List.
DAB Band
WhentouchtheDABbandbutton,thebandwill
change as below DAB1->DAB2->DAB3->DAB1···
Preset Scan
Preset Scan tunes to the Services stored in the preset
list in order.
1. Touch the [DAB1/2/3] button to select the desired
band.)
2. Touch the [ ] button to start the Preset Scan.
The unit starts scanning each service for playing 10
seconds sequentially.
3. When the desired service is tuned in, touch the[ ]
button again to stay in that service.
Service Link Setting
You can select Service Link mode from On or OFF. If
this setting is set to On, and current Service signal gets
weak, it is to be linked to the service with better signal.
1. Touch the option button[ ] to open option menu
display.
1. Touch the [ ] button to switch On or OFF.
Note:
Service Link is not currently supported in Australia.