Clark C50sD - Truck Data and Capacity Plate

Operator Controls 3-25
Section 3. Operator Compartment and Controls
Truck Data and Capacity Plate
1. Truck model number or
registered name.
2. Truck serial number -An
identification number
assigned to this particular
truck and should be used
when requesting informa-
tion or ordering service
parts for this truck from your
authorized CLARK dealer.
The serial number is also stamped on the frame.
3. Attachment description (if any installed) - The user must see that
the truck is marked to identify the attachment(s), including the
weight of the truck/attachment combination and truck capacity
with the attachment.
4. Capacity rating, load center, and lifting height data - Shows the
maximum load capacity of this truck with relation to load centers
and fork heights (see diagram on plate). Personal injury and
damage to the truck can occur if these capacities are exceeded.
Do not exceed the maximum capacity specified.
5. Truck weight - The weight of the truck without a load on the
forks. This weight plus the weight of the load must be consid-
ered when operating on elevators, elevated floors, etc. to be
sure they are safe.
CAUTION
!
When attachments are added or if the truck is modified,
the capacity of the truck may be affected. Contact your
authorized CLARK dealer for a new nameplate showing
the revised capacity.
IMPORTANT
OSHA requires prior written approval from the manufac-
turer before any modifications affecting capacity or safety
may be made.
1
2
3
4
5