Operator Controls 3-7
Section 3. Common Truck
Truck Data and Capacity Plate
1. Truck model number
or registered name.
2. Truck serial number—
A
n identification num-
ber assigned to this
p
articular truck and
should be used when
requesting informa-
tion or ordering ser-
vice parts for this
t
ruck from your autho-
rized CLARK dealer.
The
serial number is also stamped on the frame.
3. Attachment description (if any inst
alled). The user must see that
the truck is marked to identify the attachment(s), including the
weight of the truck/attachment combination and truck capacity
with the attachment.
4. Capacity rating, load center, and lif
ting height data—Shows the
maximum load capacity of this truck with relation to load centers
and fork heights (see diagram on plate). Personal injury and
damage to the truck can occur if these capacities are exceeded.
Do not exceed the maximum rated capacity.
5. Truck weight—The approximate weight of the truck without a
load
on the forks. This weight plus the weight of the load must
be considered when operating on elevators, elevated floors, etc.
to be sure they are safe.
When attachments are added or if the truck is modified,
the capacity of the truck may be affected. Contact your
authorized CLARK dealer for a new nameplate showing
the revised capacity.
OSHA requires prior written approval from the manufac-
turer before any modifications affecting capacity or safety
may be
made.
To Next Page
Loading...
