5-15
Section 5. Operating Procedures
Operate your lift truck only in areas that have been
approved for your lift truck type designation. Certain
areas contain flammable gases, liquids, dust, fibers, or
other hazardous materials. Lift truck operations in these
areas must have special approval. These areas must be
designated to show the type of lift truck approval required
for operation in the area. Be aware that changes to special
equipment or poor maintenance can cause the lift truck to
lose its special approval.
Be sure that your truck is the correct fire safety type for
t
he area in which you are working. The proper type
designation for this truck is listed on the nameplate. In
areas classified as hazardous, use only trucks approved
for use in those areas. If you are unsure of the
classification of the area you wish to enter, check before
entering.
Adjusting the Load Forks
The load forks are adjustable on the
hanger shaft. Forks should be spaced
a
s far apart as the load being carried
will allow. Both forks should always be
the same distance from the center of
the fork carriage. To adjust the forks,
raise the carriage slightly. Tilt the
upright fully forward to reduce friction
and make the forks slide easier. Unlock
the fork locking pins. Position the forks. Secure the fork locking pins.
Forks are heavy, keep fingers clear.
Move forks by pushing with one foot
while holding on to the load back
rest with hands. Be sure to have firm
footing before attempting to move
forks. Do not attempt this where the
floor is slippery or wet.
To Next Page
Loading...
