Clark GEX 40 - Page 116

Index-2
Long and Wide Loads ............... 2-3
Loose Loads .............................. 2-2
Low Overhead Clearance .......... 2-4
N
No Riders .................................. 1-5
O
Operator Controls ...................... 3-3
Operator Protection ................... 1-7
Operator Safety Warning
Decal.......................................... 3-8
Operator/Tip-Over...................... 3-8
Operating Safely ...................... 5-11
Operator Daily Inspection ............ vii
P
Parking..................................... 1-15
Parking Brake ............................ 3-4
Parking Brake Lever ................. 3-4
Parking Brake Pedal ................. 3-4
Parking Brake ......................... 8-16
Pallets and Skids ....................... 2-8
Pedestrians................................ 1-6
Periodic Maintenance Checks ... 8-5
Picking Up and Moving
Loads ....................................... 5-17
Pinch Points............................... 1-9
Planned Maintenance .................. vii
Planned Maintenance ................ 8-2
Planned Maintenance Intervals . 8-3
Plugging................................... 5-10
Positioning Forks and Upright.... 5-9
PM Report Form ...................... 8-10
R
Ramps ..................................... 1-11
Rear Swing ............................... 2-3
Right-Angle Stacking ................. 2-6
Routine Servicing and
Maintenance .................................vi
S
Safe Maintenance Practices ...... 8-6
Safety Signs and Safety
Messages .....................................x
Seat Adjustment ........................ 3-3
Seat Belt.....................................1-4
Service and Parking Brakes ....8-16
Service Brake.............................3-5
Skids ..........................................2-8
Stacking .................................. 5-18
Starting from a Safe Condition ...5-3
Starting the Truck.......................5-4
Steering System.........................3-5
Steering System ......................8-18
Surface and Capacity ...............1-12
T
Tilt Control Function .................. 3-6
Tip-Over .................................. 1-13
Tire Maintenance......................1-16
Compartment..............................4-3
Towing Precautions................... 7-2
Towing Procedures ....................7-3
Transistorized Traction
Control......................................8-19
Travel .......................................1-10
Traveling with a Load ...............5-16
Truck Data and Safety Plate ......3-7
Truck Description .......................3-2
U
Unloading ................................ 5-17
Upright Warning Decal .............. 3-9
V
Visual Checks.............................6-3
Visual Inspection .....................8-11
W
What to do in Case of
a Tip-over .................................1-14
Wheels and Tires .....................8-15