15
2) View DTCs and their definitions on screen.
$09 Pd 1/6
P0115 Generic
Engine Coolant Temperature
Sensor 1 Circuit
The control module number, sequence of the DTCs, total number of
codes detected and type of codes (Generic or Manufacturer
specific, Stored or Pending codes) will be observed on the upper
right corner of the display.
3) If more than one DTC is found, use the SCROLL button as
necessary until all the codes have been shown up.
If no codes are detected, a “No codes are stored in the module!’
message is displayed on the screen.
If retrieved DTCs contain any manufacturer specific or enhanced
codes, the display indicates “Manufacturer Control”.
$09 4/8
P1324 Other
Manufacturer Control
4) Press the ENTER/EXIT button to return to the previous menu.
4.3 Erasing Codes
CAUTION: Erasing the Diagnostic Trouble Codes allows the Scan Tool
to delete not only the codes from the vehicle’s on-board computer, but
also “Freeze Frame” data and manufacturer specific enhanced data.
Also, the I/M Readiness Monitor Status for all vehicle monitors is reset
to Not Ready or Not Complete status. Do not erase the codes before
the system has been checked completely by a technician.
This function is performed with the key ON and engine off (KOEO). Do
not start the engine.
1) If you decide to erase the DTCs, use the SCROLL button to select
the ERASE codes from the Diagnostics menu by pressing the
ENTER/EXIT button.
To Next Page
Loading...