Clarke IBC20 - Charging Settings

9
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
CHARGING SETTINGS
The IBC20 has the following selectable charging settings:
M
ODE DISPLAY
POWER
LIGHT
BOOST
LIGHT
EXPLANATION
STANDBY ---------- Blinks Unit not charging or providing any
power. If you want charging to
pause, press the ON/OFF button &
the unit will enter standby mode.
12V/2A 2A Yellow
On
Press the CURRENT button repeatedly
until 2A is shown.
This mode is recommended for 2-60
AH batteries.
12V/4A 4A Yellow
On
Press the CURRENT button repeatedly
until 4A is shown.
This mode is recommended for 2-120
AH batteries.
12V/6A 6A Yellow
On
Press the CURRENT button repeatedly
until 6A is shown.
This mode is recommended for 10-
180 AH batteries.
12V/8A 8A Yellow
On
Press the CURRENT button repeatedly
until 8A is shown.
This mode is recommended for 20-
240 AH batteries.
12V/10A 10A Yellow
On
Press the CURRENT button repeatedly
until 10A is shown.
This mode is recommended for 40-
300 AH batteries.
12V/15A 15A Yellow
On
Press the CURRENT button repeatedly
until 15A is shown.
This mode is recommended for 50-
400 AH batteries.
24V/3.5A 3.5A Blue
On
Press the VOLTAGE button to select
24V, then press the CURRENT button
repeatedly until 3.5A is shown.
This mode is recommended for 14-
115 AH batteries.