15
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
DC POWER (FOR CHARGING CAR BATTERIES ONLY)
1. Set the economy control switch to
‘OFF’.
2. Start the generator. See page 12.
3. Connect the battery charging
leads to the battery.
• Make sure you clamp the red
wire
to the positive (+) terminal
and the black wire to the
negative (-) terminal of the
battery.
4. Connect the battery charging
leads to the generator.
• The battery will begin to charge.
5. Monitor the voltage across the battery r
egularly during charging and
disconnect the battery when the voltage reaches 14.4 volts.
CAUTION: WHEN DISCONNECTING THE BATTERY, ALWAYS DISCONNECT
THE NEGATIVE LEAD FIRST.
DC OVER LOAD PROTECTOR
If the DC overload protector
activates, wait for a few minutes and
then press the reset button shown on
the right.
WARNING: FOR YOUR SAFETY PERFORM THE FOLLOWING INSTRUCTIONS
IN THE ORDER SHOWN.
To Next Page
Loading...
