22
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
The generator fails
to
start
Engine switch is off Set the engine switch to ‘on’
Not enough oil in the
gene
rator
Add more oil, See page 10
No fuel Add more fuel, See page 11
Spark plug not working
correctly
Change the spark plug, See
page 20
The generator fails
to
g
enerate
electricity
The device you are trying to
power is faulty
Make sure the device you want to
power is working properly
The overload indic
ator is on Remove the appliance
immediately, do not connect any
appliance that requires more than
2.2 KVA.
(DC supply only) The DC
Ov
erload protector h
as
activated.
Press the reset button. See page 15
The generator is
d
i
fficult to start
The air filter is dirty Clean the air filter. See page 19
If this does not solve your problem, please contact the CLARKE service
department. see below.
To Next Page
Loading...
