11
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
USING THE COMPRESSOR (MODEL 1100C ONLY)
For inflating tyres, attach the air hose to the tyre by pushing the connector
down firmly on the tyre adapter and locking in place by turning the connector
locking lever through 90 degrees.
Switch on the compressor. The gauge will indicate the air pressure in the tyre.
Pull out the hose and use one of the
adaptors to connect to the
accessory being inflated.
• Three adapters are provided
which allow the compressor to
be used for inflating air beds,
footballs etc.
Select the appropriate adapter and
push the threaded end firmly into the
air hose connector, locking it in place
by turning the connector locking lever through 90 degrees.
Turn on the compressor using the switch and note the pressure displayed on
the gauge. Switch off when the item is fully inflated. Do not exceed the duty
cycle stated in the specification.
WARNING: DO NOT RUN THE COMPRESSOR FOR MORE THAN 10 MINUTES.
ALLOW A 10 MINUTE PERIOD TO ELAPSE BEFORE SWITCHING ON AGAIN.
CAUTION: THE AIR PRESSURE GAUGE ON THIS PRODUCT IS FOR
GUIDANCE ONLY. IT IS IMPORTANT THAT YOU CHECK YOUR TYRE
PRESSURE WITH A PRESSURE CERTIFIED GAUGE.
To Next Page
Loading...
Need help?
General
