12
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
CONNECTING ELECTRICAL APPLIANCES
The generator can supply both 230V AC and 12V DC
AC POWER
1.
Start the engine. See page 10.
2. Make sure that the AC Breaker is
set to the ON
(up) position.
3. Connect the appliance to the
generato
r.
• Make sure the appliance is
turned off before connecting it
to the generator.
• The voltage being supplied is
shown on the voltmeter.
AC BREAKER
The AC Breaker will activate if the generator is overloaded,
If the AC Breaker
activates,
1.
Remove any connected devices
from the generator
2. Wait for a few minutes
3. Set the AC breaker to the ON (up)
positio
n.
4. Reconnect the devices to the
gene
rator, making sure your do
not exceed the maximum
capacity of the generator.
CAUTION: MAKE SURE THAT THE APPLIANCE BEING CONNECTED IS IN
GOOD WORKING ORDER, IF IT BEGINS TO ACT ABNORMALLY OR STOPS
SUDDENLY, DISCONNECT IT FROM THE GENERATOR
CAUTION: MAKE SURE THE APPLIANCE DOES NOT EXCEED THE MAXIMUM
RATED LOAD FOR THE GENERATOR.
CAUTION: ANY DEVICE WHICH CONTAINS AN
INDUCTIVE LOAD E.G.
DEVICES THAT CONTAIN A MOTOR
MAY REQUIRE MORE CURRENT ON
STARTUP.
To Next Page
Loading...
Need help?
General
