Clarke Super 7R Edger 07013A User Manual

Form No. 70402B 6/09 revised 9/12
This book has important information for the use and safe operation of this machine. Failure to read
this book prior to operating or attempting any service or maintenance procedure to your Clarke
American Sanders machine could result in injury to you or to other personnel; damage to the
machine or to other property could occur as well. You must have training in the operation of this
machine before using it. If your operator(s) cannot read this manual, have it explained fully before
attempting to operate this machine.
All directions given in this book are as seen from the operator’s position at the rear of the ma-
chine.
Super 7R Edger
English (2 - 9)
Español (10 - 17)
Français (18 - 25)
ES
EN
FR
Operator’s Manual / Manual del operador / Manuel de l’utilisateur
Models: 07013A, 07125A, 07098A
READ THIS BOOK
LEA ESTE MANUAL
LISEZ CE MANUEL

Clarke Super 7R Edger 07013A Specifications

General

Power	750W
Voltage	230V
Speed	2800 RPM
Disc/Pad Size	178mm
Model	07013A
Category	Sander

Summary

Operator Safety Instructions

General Power Tool Safety Warnings

Critical safety warnings applicable to all power tools.

Work Area Safety

Maintaining a clean and safe environment during operation.

Electrical Safety

Precautions related to power supply and electrical hazards.

Personal Safety

Protective measures for the operator's well-being.

Power Tool Use and Care

General Use and Maintenance

Guidelines for operating, maintaining, and storing the power tool.

Safety Warnings for Sanding Operations

Specific hazards and precautions for sanding tasks.

Kickback and Additional Rules for Safe Operation

Kickback Warnings and Prevention

Understanding and avoiding kickback incidents.

Additional Safe Operation Rules

Further essential safety practices for operation.

Machine Overview and Specifications

Know Your Machine Components

Identification of the machine's main parts.

Machine Specifications

Technical details and ratings of the machine.

Sanding Cuts and Sandpaper

Initial Cut Procedure

Using coarse abrasives for initial finish removal.

Final Cut Procedure

Using fine abrasives for scratch removal and finishing.

Machine Set-Up

Dust Collection System Setup

Connecting vacuum or dust bag for debris collection.

Preparing Machine for Operation

Final checks and setup before starting the machine.

Operating Instructions

Adjustments and Routine Maintenance

Leveling Adjustments

Procedures for adjusting the machine's levelness.

Bearings and Lubrication

Bearing inspection and gearbox lubrication guidelines.

Specific Maintenance Tasks

Carbon Brush Maintenance

Inspection and replacement of carbon brushes.

Gearbox Lubricant Change

Procedure for changing the gearbox lubricant.

Parts Manual

Lower Assembly Parts List

List and diagram of parts for the lower assembly.

Upper Assembly Parts List

List and diagram of parts for the upper assembly.

Wiring Diagram