To Next PageTo Next Page
Need help?Do you have a question about the Clarke Super 7R and is the answer not in the manual?
Details risks of explosive environments during sanding and required safety procedures.
Addresses spontaneous combustion risk from sanding dust and proper disposal.
Warns about nail hazards causing sparks, fire, or explosion during sanding.
Warns against operating partially assembled equipment, stressing full assembly and guards.
Highlights risks from moving parts and advises keeping body parts and loose clothing away.
Details electrical shock and fire risks, stressing proper connections and cord condition.
Emphasizes wearing eye, ear, and respiratory protection during sanding operations.
Warns that unauthorized maintenance voids warranty and can cause damage or injury.
Advises against using the equipment for moving objects or climbing, or riding on it.
Stresses storing the equipment in a dry building to prevent damage.
Warns about floor damage from leaving the running equipment in one spot.
Provides an illustrated overview of the Super 7R Edger with labeled components.
Details electrical requirements, storage, motor, abrasive size, disc rate, and dust control.
Explains the purpose of the initial cut for removing finish and imperfections using coarse abrasive.
Describes the final cut for removing scratches using fine abrasive (60-80 grit).
Lists recommended sandpaper grits for various sanding tasks and wood types.
Instructions for connecting 2" and 1½" hose ends to the machine's exhaust tube.
Steps for attaching, detaching, and emptying the machine's dust bag.
Steps for attaching abrasive, positioning the machine, and securing it for use.
Guidance on connecting power, starting the machine, and sanding techniques.
Procedure for stopping the machine, disconnecting power, and safety reminders.
Instructions for adjusting caster screws to level the machine pad on the floor.
Recommendation to replace carbon brushes every 500 hours or more under heavy use.
Procedure for cleaning the dust bag to prevent pore blockage and maintain dust control.
Guidance on inspecting armature and pad driver bearings after 1500 hours of use.
Information on the machine's initial lubrication and recommended gearbox lubricant change intervals.
Detailed steps for accessing, inspecting, and replacing carbon brushes, including part numbers.
Step-by-step guide for draining old lubricant and adding new lubricant to the gearbox.
Lists part numbers, descriptions, and quantities for the Super 7R Edger.
Lists available accessory parts with their corresponding part numbers.
Lists production, service, and sales facilities in the United States.
Lists production, service, and sales subsidiaries in Europe and Australia.
Details the one-year warranty period, exclusions, and procedures for warranty claims.
Instructions for returning the warranty registration card to assist with product performance.
States that Clarke American Sanders reserves the right to make changes and use genuine parts.
General