What to do if the Clarke OBS-18 motor fails to start or runs sluggish?
If your Clarke Sander's motor fails to start or runs sluggishly, the problem might be low voltage due to an excessively long or undersized extension cord. Try using a 14 Ga extension cord that doesn't exceed 50 feet in length. If this doesn't solve the issue, the start capacitor, start switch, or motor may be defective.
What to do if my Clarke OBS-18 motor will not start?
If the motor of your Clarke Sander won't start, first check the power supply and connection. Ensure the interlock is depressed before activating the control lever.
Why does my Clarke OBS-18 Sander motor fail to start or run sluggishly?
Your Clarke Sander motor may fail to start or run sluggishly due to low voltage from an excessively long or undersized extension cord. Try using a 14 Ga extension cord, not exceeding 50' in length.
How to fix a Clarke OBS-18 when the motor will not start?
If the motor of your Clarke Sander won't start, first ensure it's getting power by checking the power supply and connections. Also, make sure the interlock is depressed before you activate the control lever. If these steps don't resolve the issue, it could be a defective switch or a bad connection.
Why does the fuse/circuit breaker repeatedly trip on my Clarke Sander?
If the fuse or circuit breaker repeatedly trips when using your Clarke Sander, it could be due to low voltage. Try eliminating the extension cord or locating the power source closer to the work site. It is also possible that the motor is defective.
Covers risks like fire, explosion, electrocution, and shock from improper operation.
Emphasizes protective gear, avoiding pressure-treated wood, and safe handling.
Warns against unauthorized alterations that void warranty and cause risks.
Procedure for safely moving the machine to a work location.
Steps for installing or replacing the floor pad on the machine driver.
Instructions for connecting a remote vacuum system using 2" or 1.5" hoses.
Steps for installing, using, and emptying the dust bag.
Procedure for operating the machine as a sander, including abrasive installation.
Procedure for operating the machine as a polisher, including pad and abrasive handling.
To Next Page
General