Clarke American Sanders B2 User Manual

Form No. 70162B 12/06 revised 3/13
READ THIS BOOK
This book has important information for the use and safe operation of this machine. Failure to read this
book prior to operating or attempting any service or maintenance procedure to your Clarke American
Sanders machine could result in injury to you or to other personnel; damage to the machine or to
other property could occur as well. You must have training in the operation of this machine before
using it. If your operator(s) cannot read English, have this manual explained fully before attempting
to operate this machine.
Si Ud. o sus operadores no pueden leer el Inglés, se hagan explicar este manual completamente
antes de tratar el manejo o servicio de esta máquina.
All directions given in this book are as seen from the operator’s position at the rear of the machine.
B2
7" Spinner
Edger (CE)
Operator's Manual
MODEL: 07097A

Clarke American Sanders B2 Specifications

General

Motor	1.5 HP
Voltage	120V
Drum Speed	1750 RPM
Drum Size	8 inches
Sanding Width	8 in.

Summary

Clarke American Sanders B2 7" Spinner Edger (CE) Operator's Manual

READ THIS BOOK

Important information for safe operation and training requirements before use.

OPERATOR SAFETY INSTRUCTIONS

Explosive Environment Safety Procedures

Procedures to prevent explosions from flammable dust, vapors, and ignition sources.

ADDITIONAL SAFETY INSTRUCTIONS

Equipment Assembly, Moving Parts, and Electrical Safety

Safety regarding assembly, moving parts, electrical connections, and cords.

Personal Protective Equipment and Operational Safety

Importance of PPE, power switch safety, and preventing floor damage.

INTRODUCTION AND MACHINE SPECIFICATIONS

MACHINE SET-UP

Remote Vacuum Dust Collection Set-up

Included Dust Bag Set-up

MACHINE SET-UP PROCEDURES

Initial Familiarization and Abrasive Replacement

OPERATING INSTRUCTIONS

Machine Operation Steps

Steps for operating the machine, including connecting power, setting speed, and starting.

Dust Bag Handling and Safety

Safe practices for emptying the dust bag and preventing spontaneous combustion.

SANDING CUTS AND SANDPAPER

Initial Sanding Cut

Final Sanding Cuts

MAINTENANCE

Dust Control System Maintenance

Sandpaper Disc Angle Adjustment

MAINTENANCE PROCEDURES

Gearbox Lubricant Change

Carbon Brush Inspection and Replacement

Procedure for inspecting and replacing carbon brushes based on wear.

MAINTENANCE PROCEDURES (CONT.)

Carbon Brush Replacement Details

Detailed steps for replacing carbon brushes, ensuring proper engagement.

WIRING DIAGRAM

Electrical Schematics