What to do if my Clarke RS-16 HDTR machine does not run?
If your Clarke Sander machine isn't running, first, ensure the plug is properly connected both to the machine and the wall outlet. Next, check the building circuit breaker. If the issue persists, call for service.
Why does my Clarke RS-16 HDTR wobble during operation?
If your Clarke Sander wobbles during operation, it could be due to several reasons. It might be a defective pad, or the machine was left sitting on the pad for an extended period, causing the pad to 'take a set'. Ensure the pad is properly seated into the pad holder bristles. Finally, a warped block on the brush or pad holder could also be the cause; if so, replace it.
Defines DANGER, WARNING, CAUTION and lists initial safety rules for operation.
Details critical safety advice regarding machine use, environment, and modifications.
Provides detailed technical data for the RS-16 HDTR model.
Guidance on unpacking, inspecting for damage, and handling delivery issues.
Identifies key parts of the machine using a diagram (Figure 1).
Step-by-step instructions for attaching and detaching the pad driver.
Essential steps for proper grounding of 120V machines to ensure electrical safety.
Rules and specifications for selecting and using extension cords safely.
Detailed steps for starting, running, and controlling the machine.
Instructions for cleaning, inspection, and proper storage of the machine.
Common causes and solutions for instability while the machine is running.
Troubleshooting steps for when the machine fails to start or operate.
Exploded view illustrating machine components with reference numbers.
Detailed list of all parts, including part numbers and quantities.
Diagrams showing the electrical system and wiring for the machine.
General| Sander type | Random Orbital Sander |
|---|---|
| Disc diameter | 125 mm |
| Power | 300 W |
| Power source | Electric |
| Dust Extraction | Yes |
To Next Page