Clarke ULTRA SPEED BURNISHER 1700 User Manual

Form No. 70127B 4/01 CLARKE TECHNOLOGY Printed in the U.S.A.
READ THIS BOOK
This book has important information for the use and safe operation of this machine. Failure to read
this book prior to operating or attempting any service or maintenance procedure to your ALTO
machine could result in injury to you or to other personnel; damage to the machine or to other property
could occur as well. You must have training in the operation of this machine before using it. If your
operator(s) cannot read English, have this manual explained fully before attempting to operate this
machine.
All directions given in this book are as seen from the operator’s position at the rear of the machine.
For new books write to: ALTO U.S. INC., 2100 Highway 265, Springdale, Arkansas 72764.
Operator's
Manual
ULTRA SPEED
BURNISHER
1700
E

Clarke ULTRA SPEED BURNISHER 1700 Specifications

General

Brand	Clarke
Model	ULTRA SPEED BURNISHER 1700
Category	Floor Machine
Language	English

Summary

Operator Safety Instructions

Safety Level Definitions

Defines safety levels: DANGER for severe injury/death, WARNING for injury, CAUTION for damage.

General Safety Precautions

Covers hazards like flammables, assembly, electrocution, damaged cords, and unauthorized service.

Electrical Connection and Safety

Grounding Requirements

Emphasizes proper grounding to prevent electric shock; consult electrician if unsure.

Machine Assembly and Preparation

Pad Installation Procedure

Step-by-step guide for safely removing, cleaning, and attaching burnishing pads.

Machine Operation

Starting and Stopping Procedure

Procedure to start and stop the machine, including handle and lever operation.

Operational Best Practices

Tips for effective use, pad changes, and handling circuit breaker trips.

Circuit Breaker Functionality

Care and Maintenance

General Care and Storage

Maintenance Inspections and Repairs

Recommends annual inspections and emphasizes repairs by authorized personnel only.

Troubleshooting Common Problems

Machine Will Not Run

Diagnoses issues like no power, damaged cord, worn pad, or defective switch/breaker.

Machine is Noisy or Vibrating

Addresses causes like motor issues, dry bearings, slipping belts, or incorrect pad installation.

Maintenance Procedures

Motor Maintenance Details

Checking Commutator and Brushes

Commutator Condition Analysis

Carbon Brush Replacement Guide

Component Part Numbers

Electrical Schematic

Circuit Diagram Overview

Motor Components and Parts

Motor Exploded View

Motor Parts List