Clarke Focus II - User Manual

Questions and Answers

J
Joan GallowayJul 27, 2025
What to do if the recovery water vacuuming is insufficient on my Clarke Floor Machine?
- S
  Sandra PruittJul 27, 2025
  If the recovery water vacuuming is insufficient in your Clarke Floor Machine, several issues could be the cause. The recovery water tank might be full, so you should empty it. The hose could be disconnected from the squeegee, in which case you should connect it. The vacuum grid might be clogged, or the float stuck closed, requiring you to clean the grid or check the float. The squeegee could be dirty, or the blades worn or damaged, so you should clean and check the squeegee. The tank cover might not be properly closed, the gasket damaged, or the compensation hole clogged; close the cover correctly, replace the gasket, or clean the compensation hole. Finally, the recovery water tank itself might be dirty, so ensure you clean it.
T
Tyler FrazierAug 2, 2025
Why does the squeegee leave marks on the floor when using my Clarke Focus II?
- H
  harperwhitneyAug 3, 2025
  If the squeegee on your Clarke Floor Machine leaves marks on the floor, it could be due to several reasons. There might be debris under the squeegee blades, which you should remove. The squeegee blades could be worn, chipped, or torn, requiring replacement. Alternatively, the squeegee might not have been adjusted with the knob, so try adjusting it.
M
Molly HutchinsonAug 11, 2025
How to fix Clarke Floor Machine when the motors do not work and no warning light turns on?
- H
  hatfieldloriAug 11, 2025
  If the motors on your Clarke Floor Machine aren't working and no warning light turns on, it could be due to a disconnected battery connector; ensure you connect it. Alternatively, the batteries might be completely discharged, so you should charge them.
P
Patrick Walters DDSAug 18, 2025
What does it mean when the 3 battery charge indicators are flashing simultaneously on my Clarke Focus II?
- N
  Nicole RobinsonAug 19, 2025
  If the 3 battery charge indicators are flashing simultaneously on your Clarke Floor Machine, it may indicate a brush motor overload. Try using less aggressive brushes and avoid working with extra pressure activated. It could also be due to foreign materials (like tangled threads) preventing the brush from rotating. In this case, clean the brush hub.