Clarke Focus II User Manual

ENGLISH
24
Operator’s Manual - FOCUS
®
II L17 - S20 - L20 - L20 Cyl. - BOOST
®
L20
SQUEEGEE CLEANING
NOTE
The squeegee must be clean and its blades must be in
good conditions in order to get a good drying.
CAUTION!
It is advisable to wear protective gloves when
cleaning the squeegee because there may be sharp
debris.
Drive the machine on a level oor.1.
Turn the ignition key (A, Fig. 25) to "0".2.
Lower the squeegee (B) with the lever (C).3.
Loosen the knobs (D) and remove the squeegee (B).4.
Disconnect the vacuum hose (E) from the squeegee.5.
Clean the steel or the aluminum squeegee (Fig. 26). Clean 6.
the compartments (A) and the hole (B) especially. Check the
front blade (C) and the rear blade (D) for integrity, cuts and
tears; if necessary replace them (see the procedure in the
following paragraph).
Assemble the squeegee in the reverse order of disassembly.7.
Figure 25
Figure 26
B ENGLISH.indd 24 14/04/2010 12.48.45

Clarke Focus II Specifications

General

Cleaning Path	20 inches
Power Source	Battery
Brush Motor	0.75 hp
Battery Voltage	24 V
Voltage	36V
Vacuum Motor	0.5 hp