Clas Ohlson SR1000 - Use; Programming the remote control; Entering the control code

4
English
5. Use
5.1 Programming theremote control
There are three ways of setting up theremote control.
• By entering thecontrol code.
• By searching through thelibrary.
• By auto-searching.
5.2 Entering thecontrol code
You can choose which type of device you want to have on thedifferent function buttons.
Forinstance, you can choose SAT, STB or one of theother buttons if you want to add
acode for device of type DVB-T (terrestrial receiver).
5.2.1 Key in thecode as follows:
1. Find thecode list supplied and search under theheading for thedevice type that
matches your equipment.
• TV, TV/VCR COMBO - Codes for TV sets and TV sets with built-in video.
• VCR – Codes for video devices
• SAT/CTV/DVB-T, DIGITAL TV STB/BROADBAND/AXILIARY STB/
HDD VIDEO RECORDER – Codes for satellite receivers, cable TV receivers,
terrestrial TV receivers, digital receivers connected to anetwork, etc. Codesfor
digital receivers for cable TV and theterrestrial network.
• DVD – DVD players
• DVD-R – DVD recorders
• TV/DVD COMBO – TV sets with built-in DVD player.
• DVD/VCR COMBO – DVD and videotape recorders
• MEDIA CENTER – PC
• HOME CINEMA SYSTEMS (DVD&AUDIO)
• CD PLAYER
• AUDIO AMPLIFIER/RECEIVER/TUNER
• AUDIO TAPE PLAYER
• MINI HIFI SYSTEM
• LD – Laser Disc
2. Then search under that heading for thecode for themake of your device, eg
Philips. Eachcode has four digits. Ifthere is more than one code for your make of
device, start with thefirst one.
3. Switch on theTV (for example) manually with theoriginal remote control.
Choosechannel 1.
4. Press and hold down followed by therelevant device, eg . TheLED lights up.
5. Release both buttons.
6. Key in your four-digit control code with the – keys. The LED goes out
immediately.
Check that theremote control works with thedevice you have just programmed.