11
English
9. Memory
1. Press once on [MEM] (2) to view the readings that have been saved to
the memory. If the voice function is activated, the readings will be spoken
out loud.
2. Normally, the latest reading will be displayed first, push [MEM] (2) to go
back to the previous reading. If there are no earlier readings saved, the
“-” symbol will appear.
3. Max. 30 readings can be displayed with temperature, date and running
number order (latest reading first).
4. The display reverts to time display mode 5 seconds after the last button
was pressed.
10. Recommendations
1. If you are unaccustomed to using the thermometer it is a good idea to
take the temperature of the same ear three times to begin with and save
the highest reading in the memory.
2. Wait 30 seconds before taking the temperature of the same person again.
3. Healthy people usually have the same temperature in both ears. If you
check both ears and the results differ, you should save the readings from
the ear with the most consistent and highest temperature.
4. Make sure that the ear is clean before using the thermometer.
11. Care and maintenance
11.1 Cleaning
1. Wipe off the thermometer using a soft cloth.
2. Clean the sensor like this: Wipe the sensor carefully using a soft cloth or
cotton wool moistened with surgical spirit. Wait until the surgical spirit has
evaporated before using the thermometer.
3. Never use water, abrasive cleaning agents or solvents to clean the
thermometer.
11.2 Storage
1. Clean the thermometer and attach the forehead adapter before packing
it away.
2. Store the thermometer where it is not exposed the direct sunlight, high
temperature, dust, naked flames, vibrations or impacts.
3. Take the batteries out if the thermometer is not to be used for a long time.
To Next Page
Loading...
Need help?
General
