Clas Ohlson WS2015H - User Manual

Questions and Answers

B
bellthomasAug 2, 2025
What to do if Clas Ohlson WS2015H receiver cannot receive signals?
- K
  Kathryn BarronAug 2, 2025
  If the Clas Ohlson Thermometer receiver isn't displaying signals, try these steps: * Synchronize the units again. * Ensure the temperature isn't below -30 ºC, as this may affect signal reception. * Replace the sensor batteries. * Move the receiver and sensor closer, and keep the sensor away from electrical interference. * Experiment with the positioning of the units to overcome obstacles or walls that may be affecting the range.
T
Tamara RobbinsAug 9, 2025
Why is my Clas Ohlson WS2015H behaving abnormally?
- R
  Ryan CampbellAug 9, 2025
  If your Clas Ohlson Thermometer functions are behaving abnormally or not working, reset the instrument by replacing the batteries in both the sensor and the receiver.
C
chillAug 17, 2025
Why is my Clas Ohlson WS2015H temperature too high?
- S
  Stephanie WilliamsAug 17, 2025
  If the temperature reading on your Clas Ohlson Thermometer transmitter is too high, make sure that the transmitter is not placed in direct sunlight or next to a heat source.
L
Lauren CervantesAug 26, 2025
How to sync Clas Ohlson WS2015H transmitter and receiver?
- B
  Brittany CombsAug 26, 2025
  If the temperature displayed on the Clas Ohlson Thermometer transmitter doesn't match the outdoor temperature on the receiver, allow 1–2 minutes for the units to synchronize. If the issue persists, resynchronize the units by holding the [Channel] button for three seconds until you hear a signal.