EasyManuals Logo

Clas Ohlson TCD-982WE User Manual

Clas Ohlson TCD-982WE
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
E N G L I S H
Connection of speakers
Connect the right and the left speaker to the right (R) and left (L) speaker outlet
(28) on the back of the device.
Connecting to the power point
1. Connect the mains cord to a wall socket. Check that the voltage (V) which is
shown in the marking table on the back of the device is the same as in your
local electrical network (230 V AC, 50 Hz). Get advice from the retailer or at a
place of service if that is not the case.
2. To shut the power off completely pull out the plug from the wall socket. Also
pull out the plug from the wall socket during strong thunder storms to protect
the device.
Use the record player
1. Remove the pickup needle protection from the tonearm.
2. Set the function switch (15) in position PHONO to turn on the record player.
3. Place a record on the turntable. Some 45 rpm records have a large hole in the
centre and then the clamp (23) is needed for the record to be played.
4. Choose the right speed for the record with the speed control (25).
5. Lift and hold the tonearm over the record. The turntable now starts spinning.
6. Carefully lower the tonearm at the beginning of the wanted track.
7. The playing of the record now begins. Adjust the volume to the desired level
with the volume control (7 & 8).
8. Lift the tonearm back to the pickup needle holder when the playing is done.
The turntable stops spinning.
Note:
Some records have the end indication outside of the record player’s ”auto-stop”
– range. This means that some records stop playing even before the last track
of the record. This can be helped by setting the switch [Auto stop] (30) in
position OFF.
Note:
The record will keep spinning even when the last track has been played. To stop
the record set the switch [Auto stop] (30) in position ON or set the function switch
(15) in position OFF.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Clas Ohlson TCD-982WE and is the answer not in the manual?

Clas Ohlson TCD-982WE Specifications

General IconGeneral
BrandClas Ohlson
ModelTCD-982WE
CategoryTurntable
LanguageEnglish

Related product manuals