Classeq Under Counter Range - User Manual
For safety reasons your warewasher MUST be bonded to adjacent metalwork or
earthed so that it is the same potential (i.e. voltage).
A means for disconnection that has all poles separation of more than 3mm must
be incorporated in the fixed wiring in accordance with wiring rules (►4.3).
If a mains supply cable is damaged, it must be replaced by a cable supplied by
Classeq, its service agents or similar qualified persons, in order to avoid hazards.
All mains electrical work must be carried out in accordance with local and
national regulations, and by a qualified electrician (►4.4.1).
The warewasher MUST be disconnected from its power source during cleaning,
servicing or when replacing parts (►7).
Ensure the base of the warewasher is never submerged or standing in water
when operating the warewasher (►7).
The warewasher should only be operated at or within the voltage specified on
the rating plate (►2.3).
If Classeq warewashers are used outside the designation for the appliance, you
invalidate your warranty and make the appliance unsafe.
Maximum inlet water pressure is 400 kPA and minimum inlet water pressure is
200 kPA.
For water inlet pressures >400 kPA – a pressure reducing valve is required.
Use only the hose supplied with your warewasher to connect it to the water
supply. Old existing, defective or damaged water supply hoses MUST NOT be
used (►4.5.3).
The installer and user are responsible for ensuring the installation and operation
of this warewasher are in accordance with this Manual and local and national
regulations (►4).
DO NOT use electrical extension lead(s) to supply power to your warewasher
(►4.4.1).
To Next Page
Loading...
