Classeq D500DUOWS - Warewasher will not turn on; Warewasher fills slowly; Warewasher is overfilling

Classeq Under Counter Range - User Manual
63
Problem
Possible Cause
Solution / Check
Warewasher will not turn
on.
There is a problem with the
power supply.
Ensure the warewasher is
connected to the mains
power supply.
Check the power supply
outlet is turned on.
On 13A warewasher s check
and replace the fuse in the
plug, ensuring that the
correct rating is used.
On all ratings of warewasher
check and reset the circuit
breaker in the site fuse
board.
If the fuse or breaker keeps
tripping, request a service
callout.
Warewasher fills slowly.
There is a problem with the
water supply.
Ensure the water supply is
turned fully on.
Ensure the water supply hose
has not been trapped or
kinked.
Check that the site water
supply has not been turned
off.
Check that the site water
pressure is adequate
(►4.5.1).
Warewasher is over filling
(too much water in the
Wash Tank - visible with the
Door open, or water spills
out when the Door is
opened).
There is a problem with the
drains system.
Attempt to drain the
warewasher (►6.9). If
warewasher does not drain,
stop the warewasher and
check the site drains system.
There is a problem with the
warewasher’s control
system.
Request a service callout.