Classeq D500DUOWS - Cycle does not start

Classeq Under Counter Range - User Manual
65
Problem
Possible Cause
Solution / Check
Wash Tank not fully heated.
Check Wash Tank
temperature on Control
Panel display.
Wrong type of Prewash
Do not prewash with soap
based detergent.
Cycle does not start.
(Your warewasher has a
heat interlock that will delay
the start of the wash cycle
until all cycle start criteria
have been met. When the
criteria have been met the
heat indicator will illuminate
green and the cycle should
start. If this is not the case
please check the below
items before requesting a
service callout.)
Warewasher not turned on.
Check that the indicators and
display on the Control Panel
are illuminated.
Press the On/Off button.
Warewasher still going
through fill / heat cycle.
Check that Heating indicator
is flashing amber.
Allow enough time for the
warewasher to fill and heat
(►6.3).
Please refer to the latest
version of the Engineers
Manual on the Classeq
website for full information
regarding temperatures and
interlock settings.
Wash Tank not full.
Ensure the water supply is
turned fully on.
Ensure the water supply hose
has not been trapped or
kinked.
Check that the site water
supply has not been turned
off.
Check that the site water
pressure is adequate
(►4.5.1).