Page 3 Athena
®
Reset Foamer
WARNING
!
1. Safety
PEOPLE OR OBJECTS CAN BE HURT OR DAMAGED IF THIS UNIT IS NOT USED CORRECTLY!
Failure to read all the instructions before operating the unit may result in personal injury
or death from the improper use or the chemical solution. Anyone handling, operating
or using the unit must read, and understand, the instructions in the manual. The buyer
assumes all responsibility for safety and proper use in accordance with the instructions.
Using, or servicing, the unit without proper protective clothing,
gloves, and eye wear may result in serious injury such as burns,
rashes, eye, throat or lung damage and death. Always wear
protective clothing, gloves, and eye wear when using, or servicing,
the unit. Protect eyes, skin, and lungs against drifting spray.
Chemical solutions may pose a health risk and death if they contact the skin or eyes,
are inhaled or swallowed. Always read, and follow, all chemical safety precautions and
handling instructions provided by the chemical manufacturer and the Safety Data
Sheet (SDS) associated with the chemical solution being used before using the unit.
Pressure within the equipment may cause an unexpected release of the chemical
solution and cause serious injury such as burns, rashes, eye damage, throat or lung
damage and death. Always depressurize and clean the unit after each use. Release any
remaining air pressure by twisting the pressure relief valve to the right ½ turn. Never
leave the unit unattended while pressurized.
Using the unit with fluid temperatures above 100°F (37.77°C) may result in scalding,
burns, serious injury or death. DO NOT use a solution with a temperature above 100°F
(37.77°C).
Operating the unit when damaged or leaking may result in exposure to chemical
solutions, serious injury or death. Never use the unit if it is damaged or leaking.
Never point the discharge wand at yourself, another person, or any object you do not
want covered in chemical.
Using incoming air pressure exceeding 100 psi (7 bar) may result in pressure buildup,
explosion, serious injury or death. DO NOT exceed 100 psi (7 bar) incoming air pressure
when operating the unit.
Use of hydrocarbons and flammable products may result in explosions, fire and serious
injury or death. Never use hydrocarbons or flammable products with the unit.
Mixing an alkaline with an acid may result in a chemical reaction. Overheating of the
mixture may cause it to splatter caustic compounds or release hazardous fumes, gas
and vapors. Always flush the unit with fresh water for five (5) minutes when switching
from an alkaline to an acid or an acid to an alkaline.
To Next Page
Loading...
Need help?
General