Page 10 Athena
®
Reset Foamer
4. Maintenance
Performing any maintenance with the unit
turned ON, plugged into an electrical power
source and connected to the air and water
supply may result in serious injury or death.
Always ensure that the unit has been turned
OFF, unplugged from the electrical power
source, and disconnected from the air/water
supply before conducting any maintenance.
WARNING
!
NOTICE
Servicing, or modification, of this unit with
parts not listed in this manual may cause
the unit to operate improperly. Do not use
unauthorized parts when servicing the unit. Use
of unauthorized parts will void the warranty.
To keep your foam unit operating properly,
periodically perform the following maintenance
procedures:
• Inspect the pump for wear and leaks.
• Inspect all hoses for leaks or excessive wear.
Make sure all hose clamps and push-fittings
are in good condition and properly secured.
• Replace the filter located within the air
regulator as needed. Clean by unthreading the
air regulator bowl from the air regulator.
• Check the chemical metering tip, suction line
and strainer for debris and clean as needed.
• Drain your air compressor tank on a regular
basis to help extend pump life. An air source
with a high moisture content will accelerate
pump wear.
Note: If your air source has a high moisture
content, you may wish to install a water
separator (item number WS-20CFM, sold
separately) before the unit.
To Next Page
Loading...
Need help?
General