Page 9 Athena
®
Reset Foamer
4
7
13
11
After Use Instructions
11. Disconnect the chemical intake lines from
the chemical containers and connect it to a
container of clean water. Make sure that the
unit tank still contains water.
12. Activate the unit and allow it to run for 2-4
minutes, or until all chemical has been
fl ushed from the system.
13. Disconnect the air line from the air fi tting.
14. Open the discharge ball valve to relieve any
pressure remaining in the system.
15. Close the ball valve after all pressure has
been relieved from the system. Store the
unit with the discharge ball valve in the
closed position.
5 8 15
6
14
To Next Page
Loading...