What to do if foam from Clean Athena Reset Cleaning Equipment comes out wet?
If the foam from your Clean Cleaning Equipment is consistently wet, start by checking the air pressure on the air gauge. The air regulator is set at 50 psi (3.4 bar) at the factory, and the operating range is 40 to 80 psi (3 to 5 bar) with 5 to 10 CFM (141.6 to 283.3 l/min). Also, the check valve may need to be replaced.
What to do if solution backs up into the air regulator bowl of Clean Athena Reset?
If the solution backs up into the air regulator bowl of your Clean Cleaning Equipment, the check valve needs to be replaced.
What to do if air passes through Clean Athena Reset Cleaning Equipment pump without cycling?
If air passes through the pump of your Clean Cleaning Equipment without cycling, the pump needs to be replaced.
General| Brand | Clean |
|---|---|
| Model | Athena Reset |
| Category | Cleaning Equipment |
| Language | English |
Crucial warnings about operating the unit correctly to prevent injury or death.
Emphasizes wearing protective clothing, gloves, and eye wear to prevent injury from chemicals.
Advises on health risks of chemical solutions and adherence to Safety Data Sheets.
Details depressurizing the unit and avoiding unattended pressurized states.
Warns against using fluids above 100°F to prevent scalding and injury.
Prohibits operation of damaged or leaking units to prevent chemical exposure.
Instructs not to point the discharge wand at people or unintended objects.
Warns against exceeding 100 psi incoming air pressure to prevent explosion.
Prohibits the use of hydrocarbons and flammable products due to explosion risk.
Alerts to reaction hazards when mixing acids and alkalis, and flushing procedures.
Warns against using non-listed parts or modifying the unit, which may cause malfunction or void warranty.
Advises against air lubricators and stresses the need for dry, filtered air.
Guidance on disposing of packaging, components, and fluids safely and legally.
Details essential requirements for operating the unit, including air pressure and temperature.
Lists technical specifications like power type, capacity, dimensions, and component types.
Illustrates and labels internal components of the back plate assembly for identification.
Displays front and back views of the tank assembly, highlighting its components.
Instructions for filling the tank and chemical containers and connecting suction lines.
Steps for starting foaming by opening the discharge valve and adjusting flow.
Guidance on adjusting the flow control valve to regulate foam wetness or dryness.
Steps to flush the unit with clean water after use to remove residual chemicals.
Instructions for relieving pressure, closing the valve, and storing the unit properly.
Lists routine checks for wear, leaks, and secure fittings on the unit and hoses.
Guidance on replacing or cleaning the filter within the air regulator bowl.
Instructions to check and clean metering tips, suction lines, and strainers for debris.
Advises on draining the air compressor tank to prolong pump life and prevent wear.
Solutions for debris in the air regulator bowl or filter.
Addresses issues with pump cycling due to air pressure or faulty check valves.
Diagnoses for wet foam, including metering tip, suction line, and air pressure checks.
Troubleshooting steps for low operating pressure, including air supply and mixing mesh checks.
A comprehensive list of item numbers and their corresponding descriptions for ordering parts.
Details the 1-year warranty period, coverage, and conditions for defects in material and workmanship.
Outlines conditions that void the warranty and limits on liability and customer remedies.
Provides contact information for technical support and troubleshooting assistance.
Describes Athena Reset as a hard surface sanitizer and disinfectant, and its usage.
Explains Athena Perafoam as a foam adjuvant for full coverage and its warning.
To Next Page