Cleanco Compact 45 - Troubleshooting; Vacuum and Chemical Flow Issues; Water Pump Engagement

26
PROBLEM
CAUSE
SOLUTION
Improper throttle adjustment.
Adjust throttle to set desired vacuum
pressure.
Excessive Vacuum
Vacuum obstruction.
Inspect hoses for obstructions.
Vacuum relief valve requires
Readjust the vacuum relief valve.
adjustment.
The strainer at the inlet end of
Unclog the strainer. If damaged,
the chemical inlet line is
replace.
clogged.
Suction leak in the inlet line
Inspect inlet lines and flow meter for
Loss of chemical
leading into the pump.
air leaks or damage and replace, if
required.
With the cleaning
Chemical container is empty.
Refill container, then prime system
tool valve open, no
Chemical metering valve is
Replace valve.
chemical.
defective.
Defective cylinder in the water
Measure the pump volume. If the pump
pump.
volume is less than normal, refer to
"Loss of Pump Volume" in the
Troubleshooting section in this manual.
Chemical flow
External leak in chemical
Tighten fittings. Re-apply thread
meter indicates
piping.
sealant where required. If any fittings
flow with the tool
are damaged, replace.
valve closed.
Defective electrical connection
Examine switch, electrical connections,
in the console wiring or
and wiring. Repair any defective
defective switch.
connections. If there is power going to
the switch but not going out, replace
the defective switch.
Water pump has not been
Turn solution pump switch to on.
Water pump does
activated.
not engage.
Defective water pump clutch.
If there is power in the switch, but not
NOTE: The clutch may be
power at the clutch, replace the
manually set by inserting two
defective wire. If there is power at the
1/4 x 20 x 1/2 bolts. Line up
clutch, replace the defective switch.
the holes on the clutch and
insert the bolts. To disengage
the pump, remove the bolts.
Loose or broken water pump
Tighten or replace belts.
belts.