Safety, Operation and Maintenance Manual for Falcon (RA 530 B); Version 1.0
11
APPLICATIONS AND WORKING METHODS
1. Working methods
Effective cleaning is achieved by
following a few guidelines,
combined with your own
experience in particular areas.
Correct use of special
accessories will increase the
cleaning effect. Some basic
instructions can be found below.
2. Applications
The machine is suitable for:
• Deep cleaning of non-sensitive hard floors surfaces.
• Daily cleaning of non scratch-proof hard floor surfaces.
• Daily maintenance cleaning, normal soiled floors.
3. Chemicals
• Basic cleaner, deep cleaner
• Floor cleaner, maintenance cleaner, oil and grease remover
• Floor cleaner, scented cleaner
4. Accessories
• Squeegee assy.
• 2 x disc scrub brushes
• 1 x cylindrical brush
• Brush (soft)
• Pad driver
• Pad white
• Pad red
• Pad blue
• Pad black
• Battery (lead-acid and gel)
• Battery charger
FREEZING TEMPERATURE PRE-CAUTIONS
If it becomes necessary to store or transport the
unit where temperatures could drop below
freezing (32° F), the solution lines and valves
must be protected from freezing with a solution
of automotive radiator antifreeze.
1. Mix ½ gallon of water and ½ gallon of
anti-freeze and pour into the solution
tank.
2. Switch on machine with key switch (B1),
set the solution flow rate to “1” (C1) and
turn on solution pump (B6).
3. Let pump run until anti-freeze mixture is
coming out of machine.
4. To prevent damage to unit, allow the
auto-scrubber to reach room
temperature before using. The anti-
freeze MUST be flushed out of the
solution system with clean water before
auto-scrubber is used on a cleaning job;
otherwise, the floor may be damaged.
STORAGE OF AUTO-SCRUBBER
Always store the auto-scrubber in a dry,
protected area at temperatures above freezing.
This auto-scrubber should be stored in an
upright position. Objects should not be stored or
stacked on top of unit.
This unit should not be stored in vehicles or
areas where extreme heat or cold occurs.