EasyManuals Logo

Cleanfix Falcon User Manual

Cleanfix Falcon
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
Safety, Operation and Maintenance Manual for Falcon (RA 530 B); Version 1.0
15
TROUBLESHOOTING
Symptom: Machine does not run! No power to the machine!
Problem: Batteries not correctly installed in machine.
Solution: Install batteries correctly in machine. Follow instructions give above (see page 8 + 11).
Problem: Internal fuse or FI protection switch tripped.
Solution: Check internal fuse and FI protection switch.
Problem: Power supply interrupted.
Solution: Have power supply checked by authorized technician.
Problem: Frayed cables, damaged plug or loose internal wiring.
Solution: Have an authorized service technician check cord and replace if necessary. Have an
authorized service technician open switch panel and check for loose wire connection.
Problem: Brush motor protection switch tripped.
Solution: Allow motor to cool, press motor protection switch pushbutton, put less clean water into
the tank.
Problem: Discharge signal transmitter has activated.
Solution: Charge batteries.
Symptom: Insufficient vacuuming power! Loss of vacuum!
Problem: Tank cover/dome not properly seated or gasket on dome damaged/worn out.
Solution: Reseat tank cover correctly or replace gasket.
Problem: Vacuum hose and squeegee assembly is clogged up with dirt, or hose is not correctly
inserted into squeegee assembly.
Solution: Remove dirt and re-attach vacuum hose.
Problem: Filter in recovery tank is clogged up.
Solution: Clean filter with clean water.
Problem: Recovery tank drain hose not properly closed.
Solution: Close properly.
Problem: Wrong angle of squeegee assembly.
Solution: Adjust angle of squeegee assembly.
Problem: Defective vacuum motor.
Solution: Have an authorized service technician replace vacuum motor.
Symptom: Poor cleaning performance!
Problem: Worn brush or pads.
Solution: Replace brush or pads.
Problem: Improper chemical for cleaning job or improper dilution.
Solution: Change chemical or adjust dilution.
Service and re
p
airs should onl
y
be
p
erformed b
y
an authorized service center.
WARNING

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cleanfix Falcon and is the answer not in the manual?

Cleanfix Falcon Specifications

General IconGeneral
BrandCleanfix
ModelFalcon
CategoryScrubber
LanguageEnglish

Related product manuals