Cleanmaxx MJ1601A - Use

EN 18
Use
PLEASE NOTE!
■ It is essential that you charge up the battery fully (approx. 10 to 12 hours)
before you fi rst use the device in order to achieve the maximum charging ca-
pacity. If the battery is fully discharged during use, it must be fully charged up again
before it is next used.
■ Do not use the device for large volumes of water. Use only on vertical surfaces.
■ Do not open either of the two water tanks during use!
■ Empty the dirty water tank after each use or when the MAX marking is reached (see
the “After Use / Cleaning the Device” chapter). IMPORTANT: Do not overfi ll the
dirty water tank!
■ Do not use the device when it is connected to the mains power supply.
1. Disconnect the mains adapter (3) from the device.
2. Push the cleaning attachment (5) as far as it will go into the suction opening (6).
3. Attach the cleaning cloth (1) to the cleaning attachment using the Velcro fastener
(Picture E).
4. Fill the measuring cup (4) with water and a little window cleaning agent if necessary.
5. Pull the sealing cap (15) out of the fresh water tank (16).
6. Hold the device horizontally and pour the liquid from the measuring cup into the
opening of the fresh water tank (Picture F).
NOTE: Do not pour more than 100 ml (one full measuring cup) into the fresh
water tank!
7. Push the sealing cap as far as it will go into the opening of the fresh water tank.
8. Spray the surface which is to be cleaned: Hold the device vertically with the cleaning
attachment at the top, direct the spray nozzle (14) towards the surface and press the
spray button (8) (Picture G).
9. Turn the device around, spread the liquid with the cleaning cloth and dissolve the
dirt (Picture H).
10. Turn the device around again and switch on the suction function: Press the
On/
Off switch (7).
11. Hold the device by the handle (9), place the scraper lip (20) on the wet surface and
pull it down by applying gentle pressure (Picture I). Hold the device vertically and
do not press it on too fi rmly!
To prevent streaks from forming, do not allow water residues to dry in the air.
Do not leave the suction function constantly switched on so that the battery charge
lasts for as long as possible.
12. Once the MAX marking of the dirty water tank (17) has been reached, switch off the
device by pressing the
On/Off switch and empty the dirty water tank (see the
“After Use / Cleaning the Device” chapter).
Then continue cleaning.
Charge up the battery when the performance of the device diminishes (see the “Charging
Up the Battery” chapter).