19 EN
Accessories
• The wall bracket (A) is intended to save space when storing the device. The crevice
and brush nozzles, as well as the nozzle adapter, can be clipped into the semi-cir-
cular notches on the wall bracket.
• The brush nozzle (B) is for vacuuming cushions and textiles, and for dusting fragile
objects such as picture frames, lampshades, keyboards, books, etc.
• The crevice nozzle (H) is for hard-to-reach places like corners, crevices and re-
cesses, such as cushions and cleaning inside cars.
• The fl oor nozzle (I) is for both carpets and smooth fl oors. The foot pedal can be
used to switch between carpet and smooth fl oor. A brush folds out on the underside
of the fl oor nozzle for smooth fl oors. The fl oor nozzle can only be used with the
telescopic tube.
• The nozzle adapter (D) is needed to attach the crevice and brush nozzles to the
device, or to attach the telescopic tube to the device.
• The telescopic tube (G) makes it easier to reach ceilings, corners, tops of cabinets,
and is suitable for fl oor cleaning when combined with the fl oor nozzle.
Assembly
Attach/remove telescopic tube on device
• The nozzle adapter (D) must fi rst be plugged into the suction opening (10) to attach
the telescopic tube (G). Then plug the telescopic tube into the nozzle adapter.
• To remove, unplug the telescopic tube from the nozzle adapter and pull it out of the
suction opening.
Adjust length of telescopic tube
1. Operate the slide on the telescopic tube (G) and adjust to the desired length.
2. Let go of the slide and move the tube a little bit further, until it clicks into place.
Attach/remove fl oor nozzle
• The fl oor nozzle (I) is plugged directly into the telescopic tube (G).
• To remove the fl oor nozzle, simply unplug it from the telescopic tube.
Attach/remove crevice and brush nozzle
The crevice (H) and brush (B) nozzles can be attached to either the device itself or the
telescopic tube (G).
Telescopic tube
• To attach the telescopic tube, simply plug in the desired nozzle.
• To remove the used nozzle, simply unplug it from the telescopic tube.
Device
• To attach the nozzles to the device, the nozzle adapter (D) must fi rst be plugged
into the suction opening (10). Then plug the desired nozzle into the nozzle adapter.
• To remove, unplug the used nozzle from the nozzle adapter and pull it out of the
suction opening.
03533_Inlay_DE-EN-FR-NL_A5_V2.indb 1903533_Inlay_DE-EN-FR-NL_A5_V2.indb 19 26.07.2019 08:41:4426.07.2019 08:41:44
To Next Page
Loading...
Need help?
General
