21 EN
3. Pull the tab (7) on the dust collector forward slightly. The bottom of the dust collector
will open and the dirt will fall out.
4. To close, press the bottom on the dust collector. The tab should click audibly when
it closes.
Cleaning dust collector, HEPA fi lter, dust fi lter and fi lter holder
1. Turn the cover on the dust collector (1) counter-clockwise until it loosens.
2. Pull the fi lter holder (11) out by the handle. The dust fi lter (8) and HEPA fi lter (9) will
come out with it.
3. Turn the dust fi lter clockwise and pull out of the fi lter holder (Fig. B1).
4. Pull the HEPA fi lter out of the dust fi lter.
5. Tap the contents out of all parts and clean with a soft brush if necessary. Rinse out
with clean water if needed.
6. Wipe the dust collector with a damp cloth if needed.
Let all parts air dry fully before assembling. NOTICE: Never assemble wet or damp
components or attach them to the motor unit (F)!
Assembly
1. Set the HEPA fi lter in the dust fi lter.
2. Set the dust fi lter in the fi lter holder so that the latches are placed in the notches
provided for them, and turn counter-clockwise until it fi ts tightly (Fig. B2).
3. Insert the fi lter holder with dust fi lter into the dust collector so that the latches fi t in
the notches on the dust collector (Fig. C). The fi lter holder must fi t properly in the
dust collector without protruding at the top.
4. Set the lid for the dust collector on the dust collector; the latches must lay in the
notches provided for them, and turn clockwise tightly. There should be an audible
click as it locks into place.
5. Insert the dust collector back into the motor unit (see the “Assembly” chapter – “Re-
move/insert dust collector”).
Cleaning motor unit, telescopic tube and nozzles
• Wipe off the motor unit (F), the telescopic tube (G) and nozzles as needed with a
damp, soft cloth. Dry with a soft cloth.
• Regularly remove hair and lint from the nozzles and brushes.
Storage
• Store the device in a cool, dry, safe area out of direct sunlight and keep out of reach
of children and animals.
• For easy storage, hang up in the wall bracket (A) provided with the suction opening
(10), facing down (Fig. D1).
• The brush nozzle (B), crevice nozzle (H) and nozzle adapter (D) can be plugged into
the wall bracket for easy storage that saves space (Fig. D2).
If the device is not going to be used for a long time, take out the battery (C) as a
precaution: Press the unlock button on the battery and simultaneously pull it out
(Fig. E). To prevent the battery from draining completely, charge it occasionally
during long periods of non-use.
03533_Inlay_DE-EN-FR-NL_A5_V2.indb 2103533_Inlay_DE-EN-FR-NL_A5_V2.indb 21 26.07.2019 08:41:4526.07.2019 08:41:45
To Next Page
Loading...
Need help?
General
