Register Beltpack
¾ Make certain the Beltpack is turned Off.
¾ Press REG button on base station.
– STATUS display on the base station shows “o” for registration mode.
¾ On the Beltpack, press and hold ISO while pressing POWER and then release all buttons.
– The power lights blink red, then green and then turn off. One power light remains green.
– The registration number will appear on the base station STATUS display.
AUTO NULL Adjustment (only if using 2-wire interface)
If echo is heard in wireless Beltpacks on A or B:
¾ Use pointed object (e.g. pen) to press and hold the A or B AUTO NULL button for 2 seconds.
CAUTION: Before pressing an AUTO NULL button, be certain there are no open microphones on the wired
system. Notify wired system users that a loud noise may occur in their headsets during the auto null adjustment.
The system may be out of operation for approximately 50 seconds during this adjustment.
Local Headset Communication
¾ SEL button selects communication with A, B or ISO.
– A, B or ISO lights indicate selection.
¾ TALK button
– Press and release quickly to “latch on” for open communication.
– Press and hold while talking for momentary communication – release when nished.
¾ VOLUME control adjusts the audio level in local headset ear piece.
¾ MIC LEVEL control adjusts the audio level going out from local headset microphone.
Power Switch
STATUS AUTO NULLREG
Beltpack
Registration
Audio Channel and
Auto-Null Controls
Local Headset
Controls
The DX410 Console
Technical Support
In The Americas and Asia – Tel: +1.510.337.6600 or 1.800.462.4357 Menu option 1 • Hours: 8:00am-5:00pm Pacic Time • Web: www.clearcom.com
In Europe, Middle East and Africa – Tel: +44.1223.815000 • Hours: 8:00am-5:00pm GMT • Email: SalesSupportUS@clearcom.com
General Use
Beltpack Sidetone Adjustment:
¾ Press and hold the A button while you repeatedly press up (▲) to increase or press down (▼) to decrease
audio levels.
Changing the battery:
¾ When a Beltpack battery becomes weak, a headset voice prompt will say “Change battery.”
¾ Press the RELEASE BATTERY button on the belt clip of the pouch, and use your thumb to slide the battery
from the belt-pac.
¾ When charging the battery using the AC50 Battery Charger, the charging time is about 2.5 hours.
To Previous Page
Loading...
Need help?
General
